Electronic Theatre Controls Emphasis Lighting Control System Manual do Utilizador descarregar pdf (Página 169)

5 Blind Editing 159

Groups

If you find yourself selecting the same groupings of channels over and over, or you always

want to set levels for certain channels proportionally relative to each other, you can record

those channels with levels to a group. A group is a simple way to select multiple channels

with minimal key presses. You can record and edit groups in Stage or in Blind. In Blind, you

have access to the additional Group List and Group Spreadsheet displays.

Edit groups in Blind:

Step 1: Press [Blind]. The Blind display defaults to cues.

Step 2: Press [Group] [y] [Enter] to select group [y]. You can also use the [+] and

[-] keys to increment and decrement through the recorded groups.

Step 3: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 4: Set levels using the procedure described in Set Levels, page 89 and Moving

Light Control, page 95. “Not Recorded” will blink in the lower left corner of the

channel area.

Step 5: Press [Record] <Group> <y> [Enter], where [y] is the target group number.

Note:

When you edit cues, submasters, groups or focus points in Stage, Fader or Blind,

changes to channel levels or effects are not recorded until you press [Record] [Enter].

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 317 318

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Manual do Utilizador Página 169