Electronic Theatre Controls Emphasis Lighting Control System Manual do Utilizador descarregar pdf (Página 114)

104 Emphasis Console v2.0.0 User Manual

Adjust the parameters of a dynamic effect:

Step 1: View the dynamic effect in the Dynamic Effect editing display or by viewing the

selected cue or submaster in Blind.

Step 2: Press [S6 - Edit Parameter].

Step 3: Press:

• [1] [Enter] to select Size. Enter a size value between 0-2000%. 100% is the

normal value, less than 100 will contract the size of the movement, above

100 will expand the size of the movement.

• [2] [Enter] to select Rate. Enter a rate value between 0-2000%. 100% is the

normal value, less than 100 will slow the movement, above 100 will speed

up the movement.

• [3] [Enter] to select Offset Relation(ship). The offset relationship determines

the spread of fixtures along the path. For example, if the movement is a pan/

tilt “circle”, the offset relationship determines the spread of fixtures around

that circle. Offset relationship may be set to:

• All - all fixtures move together.

• Even - the total number of fixtures is spread evenly along the path.

• Ratios - the total number of fixtures is distributed in groupings set by

the selected ratio. For example, 1:2 creates two groupings of fixtures

(like odd/even); 1:3 creates groupings of every third fixture, and so on.

• [4] [Enter] to select Delay Relation(ship). The delay relationship determines

whether fixture groupings take turns or not. Delay relationship may be set to:

• All - all fixtures move together - no delay.

• Even - Each fixture takes a turn; the first completes a full cycle of the

dynamic effect before the next fixture starts, and so on.

• Ratios - delay is determined by groupings of fixtures set by the

selected ratio. For example, 1:2 delays two groupings of fixtures (like

odd/even); 1:3 delays groupings of every third fixture, and so on.

• [5] [Enter] to select % Distance. Percent (%) of distance determines how

long each fixture (or group of fixtures) waits for its turn to run when the delay

relationship is not set to “All”. For example, four fixtures in an even delay

relationship performing a pan/tilt “circle” with a distance of 25% will appear

to “follow the leader” around the circle.

• [6] [Enter] to select Fade. The fade setting modifies how the fixtures start

and end dynamic effects. Press:

• [0] [Enter] to set no fade, which causes the fixtures to “jump” to their

starting positions when the dynamic effect is activated.

• [1] [Enter] to fade in by size.

• [2] [Enter] to fade in by rate.

• [3] [Enter] to fade in by size and rate.

• [7] [Enter] to select the Number of Loops. A value of “0” causes the dynamic

effect to run infinitely. Any other setting will cause the dynamic to execute

that number of cycles then stop at the end of the final cycle.

• [8] [Enter] to select Form. Form settings can be used to constrain pan or tilt

in a dynamic effect. 100 is the normal value, 0-99 will compress pan, 101-

200 will compress tilt.

• [9] or [1][0] or

[1][1] [Enter] to select the Size, Rate or Form Channel. These

three settings allow you to assign any console control channel to control the

size, rate or form of this dynamic effect. You can then record levels for these

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 317 318

Comentários a estes Manuais

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Manual do Utilizador Página 114

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Electronic Theatre Controls Emphasis Lighting Control System