Electronic Theatre Controls Emphasis Lighting Control System Manual do Utilizador descarregar pdf (Página 100)

90 Emphasis Console v2.0.0 User Manual

Set levels using the level wheel (Expression/Insight only):

Step 1: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 2: Roll the level wheel away from you to raise the level, or toward you to lower the

level.

Note:

Control channels that are not part of a fixture or accessorized channel now default to

control by the Intensity attribute. If you have not modified the encoder setup of your

console (see Encoder Setup Options, page 64), the Intensity attribute will default to the

Y (Level) wheel. If you have adjusted your encoder setup to facilitate the use of moving

lights and you have moved Intensity from the Y wheel to another encoder, all control

channels that are not part of a fixture or are assigned as the intensity portion of an

accessorized channel will be controlled by that new encoder assignment.

Set levels using the trackpad (Express only)

Step 1: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 2: Slide your finger from bottom to top of the trackpad to raise the level, or from top

to bottom to lower the level. You can change the resolution of the trackpad by

pressing the coarse and fine pads to the left of the main trackpad. The coarse

pad has a rougher texture than the fine pad. When you set the resolution to

coarse, levels change faster when you slide your finger up and down. Use the

fine setting to move levels only a few points at a time.

Set levels using Frame Tables:

Step 1: Select an accessory or accessorized fixture channel using the procedure

described in Select Channels, Dimmers and Fixtures, page 86.

Step 2: Press [At][At], the value box for the accessory will appear, and you will be

prompted to enter a frame number.

Step 3: Press [x][Enter], where [x] is the number of the frame you want to use. The

accessory channel will automatically jump to the center level of the frame you

have selected.

Note:

For [At][At] to function, you must assign a frame table to the accessory channel. For

more information on assigning frame tables see Channel Attributes, page 58. For more

information on creating Frame Tables see Frame Tables, page 97

Coarse pad

Fine pad

X - Axis (Pan)

Y - Axis

(Tilt)

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 317 318

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Manual do Utilizador Página 100