Electronic Theatre Controls Emphasis Lighting Control System Especificações descarregar pdf (Página 320)

306 Ion Operations Manual

User Guidelines

Fader Wing Interaction With Ion

Ion will automatically recognize the fader wings and their configuration (10 x 2 or 20 x 2) once they

are plugged into or attached to the console. The system will configure the lower row of faders

contiguously starting with the furthest connected panel as submaster 1. The second row then

begins with the next consecutive number over the last numbered fader on the bottom row. You can

then use the fader wings as submasters, adjusting settings from either the console or the wings

themselves.

• Fader wings can only record intensity.

• Latest-Takes-Precedence (LTP): any levels set on the console will override settings on the

wings.

Fader Wing Paging

The fader wing is paged using the [Fader Controls] button on the Ion console.

To change the fader page of a fader wing:

Step 1: Press and hold the [Fader Controls] button on the Ion console. The LCD on the fader

wing will display the available pages beneath the fader bump buttons.

Step 2: Press the bump button corresponding to the page of submasters you wish to display

on the fader wing. The fader wing will display those submaster numbers after your

selection is made.

A maximum of 200 submasters are available distributed across all connected fader wings. For

example, if only one wing (2 x 10) were attached, there would be 10 pages of submasters. If there

were two wings (2 x 10) attached, there would be 5 pages of submasters.

Using the Faders

When the page is changed, the submaster LEDs will illuminate in the color of the new submaster

loaded on the page (green for additive and red for inhibitive). Fader wing submasters are not

motorized, therefore when you change pages you may have to manually reset the fader to the

proper location to reflect its current output level. If a submaster setting must be matched to gain

control, the LED will flash quickly in the appropriate color. The LED will stop flashing and illuminate

normally once the fader has been moved to the required location.

Otherwise, LED illumination states follow the conventions of the main face panel when submasters

are using fade and hold/dwell times. You may use the fader wing submasters in the same way as

you would use those on the console.

Using the Buttons

Each fader is equipped with two buttons beneath the potentiometer. The bottom button is the bump

key. The top button is the solo key.

LCD

The display at the center of the fader wing shows the sub number, label, and current value (0-

100%) of the fader above and the fader below. When the page is changed, the current value will

display the necessary percentage the fader must be set at to match the required level of the

submaster.

1 2 ... 315 316 317 318 319 320 321 322 323 324 325 ... 337 338

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Especificações Página 320