Electronic Theatre Controls Emphasis Lighting Control System Especificações descarregar pdf (Página 201)

15 Cue Playback 187

Using Stop Effect

The {Stop Effect} softkey can be used to stop all effects from operating on any or all faders, or it may

be used with the control keypad to stop a specific effect.

• To stop all effects on a fader, press [Fader Controls] {Stop Effect} & [Load] of the

associated fader.

• To stop a specific effect regardless of the fader it is operating on, press [Effect] [2] [Fader

Controls] {Stop Effect} [Enter].

When an effect is stopped, all impact of the effect is removed and the stage output is as though the

effect has never been activated.

Release a Fader

To release a fader, thereby clearing all cues from that fader, press [Fader Controls] {Release} &

[Load] for the associated fader. When a fader is unloaded, control is returned to the master fader.

If there are no values for unloaded channels from the master fader, channels are set to default.

Channels return to the master fader using the category level timing of the active cue on that fader.

If the master fader is released, the fader is cleared and any intensity values owned by that fader are

set to zero, any non-intensity parameters remain in their current state.

All fader attributes (timing disable, filters, and so on) are cleared by the release action.

Turning a Fader Off

To turn a fader off, press [Fader Controls] {Off} & [Load] of the associated fader. When a fader is

turned off, any intensities owned by that fader are driven to zero and any repetitive action (from

effects for example) are stopped. All parameters remain in their current state. The fader remains

with the current cue loaded, just shown as contributing no current values to the stage. All channels

that were previously owned by that fader are now available for control by other sources.

When the next cue is activated from any other fader, any parameters previously owned by the off-

fader will fade to the new cue (if they have an instruction in that cue). If they do not have an

instruction in that cue, intensity will fade out and non-intensity parameters remain where they are.

Press {Off} & [Load] again to turn the associated fader back on. The active cue is replayed,

following the rules for assert.

You can turn the fader back on by pressing the Go or Stop/Back button on the fader, or by executing

a [Go to Cue] for the cue list on that fader, provided the cue list is not already active on another

playback.

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 337 338

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Especificações Página 201