Electronic Theatre Controls Emphasis Lighting Control System Especificações descarregar pdf (Página 318)

304 Ion Operations Manual

Connecting Wings to Ion

Up to three (3) Universal Fader Wings may be connected together and then connected to Ion using

a USB cable only or by physically attaching them to the Ion console.

The best way to connect wings together is to attach them in order from left to right.

Connect Universal Fader Wings

Step 1: Using a #1 Phillips head screwdriver, on the underside of the wing(s) remove the two

screws securing the bumpers that will be removed from the appropriate side or sides

of the wings. The bumpers will be removed in a later step.

a: Carefully turn the wing over and place it faders-down on a clear, flat work

surface.

b: Remove and save the two screws securing the bumper to the side of the wing.

Step 2: Turn the wing over again and return it to its upright position.

Step 3: Remove the bumper(s) from the wing.

a: Right Side - Gently pull the bumper up until it is flush with the facepanel.

Left Side -Gently push the bumper down until it loosens from the facepanel.

b: Pull the bumper away from the facepanel until it is free from the wing.

Step 4: Repeat steps 2 and 3 for each side of each wing that needs to be exposed.

CAUTION:

Do not set the console on the connector side (rear panel). Instead, place it face

down on the faders.

Bumpers on

either side

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 337 338

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Especificações Página 318