Electronic Theatre Controls Emphasis Lighting Control System Especificações descarregar pdf (Página 101)

6 Setup 87

{Face Panel}

Sounds

You can adjust the frequency and length of the audible sounds that Ion delivers. Sounds are

qualified as being either an error sound or an advisory sound. Both types of sounds can be adjusted

from this setup screen in the CIA.

To adjust a sound, move the virtual slider with the mouse on the CIA. To hear the result of your

adjustment, click the {Test} button respective to the sound type, located beneath the sliders.

To turn off all sounds completely, error and advisory alike, click the {Turn Sounds Off} button. The

sound area will then be replaced with a {Turn Sounds On} button, which can be pressed to

reactivate audible signals in Ion.

Level Wheel

You can adjust the increment and acceleration effect of the level wheel from this screen as well.

To alter the number of ticks in a full turn of the level wheel, adjust the slider labeled “LW ticks”. This

will increase or decrease the amount of change effected when you use the level wheel. A higher tick

setting will increase the amount of change resulting from one turn while lower settings will decrease

the amount, making smaller adjustments easier to perform. The options range from 50 - 255 ticks.

The default is 150.

Ion also provides an adjustable acceleration feature for the Level wheel. This feature allows you to

adjust the wheel’s sensitivity to fast adjustments, thereby temporarily overriding the number of ticks

setting. To adjust the level wheel acceleration, use the virtual slider labeled “LW Acc. Factor”. The

higher the slider setting, the less sensitive the level wheel will be to acceleration. The lower the

setting, the more sensitive it is. When set low, the faster you move the wheel, the greater the

increment covered by a revolution. When movement stops, the normal LW ticks will be reinstated.

Encoder

Similar to “LW Acc. factor” (see above), the encoder acceleration factor is used to adjust the

acceleration of all encoders.

To adjust the encoder acceleration, use the virtual slider labeled “Encoder Acc. Factor”. The higher

the slider setting, the less sensitive the level wheel will be to acceleration. The lower the setting, the

more sensitive it is.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 337 338

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Especificações Página 101