Electronic Theatre Controls Emphasis Lighting Control System Especificações descarregar pdf (Página 341)

Express 125/250 User Manual, v.3.1 327

RVI ETCNet DIP switch settings

In order to enable the RVI for use on the ETCNet network, you must verify

or adjust the settings of two sets of DIP switches. You will need to use a

pin or a similar fine-pointed object to set the switches.

To set the switches, follow these steps.

1. Locate the two sets of DIP switches, visible through the right side

panel of the RVI. See the drawing below.

2. Set all six switches of the DIP closest to the front of the RVI to the Off

position (up). Set all six switches of the DIP closest to the back of the

RVI to the On position (down).

125

Installing remote video monitors

You can have additional monitors at remote locations. Connect them to

RIUs or RVIs operating on ETCNet. These remote monitors duplicate the

console’s displays.

Connect monitors to interface devices by following these steps.

1. Insert the female end of the monitor power cord in the monitor

connector, and the male end of the monitor power cord in the

interface device connector labeled Switched outlets.

2. Connect the cable to the connector labeled CRT 1.

3. Turn monitor power switch to its On position.

VGA monitor console connector

HD-DB15 female

VGA monitor pinout

1 Red video

2 Green video

3Blue video

4Ground

5Ground

6 Red ground

7 Green ground

8 Blue ground

9 not connected

10 Ground

11 Ground

12 not connected

13 Horizontal (H/V) sync

14 Vertical sync

15 not connected

125.

If using an older console and thinnet wiring, please see Using thinnet with older

consoles, page 328, for different DIP switch settings.

1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 379 380

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Especificações Página 341