Electronic Theatre Controls Emphasis Lighting Control System Especificações descarregar pdf (Página 328)

314 Appendix A Installation

Setting the port to Dimmer Doubling

If your console is controlling an ETC Sensor dimming system that can

operate in Dimmer Doubling mode, each dimmer and the port to which

the dimmer is connected must be individually set to support that feature.

Moving light fixtures cannot be patched to a doubled port.

WARNING

: Set the port mode using the procedure below BEFORE you

create your patch. Changing a port to or from Dimmer Doubler mode

unpatches all conventional lights and moving light fixtures controlled by

that port.

Use the following procedure to set a port’s mode to double. Use the

procedure given under Setting dimmers to Dimmer Doubling, page 48, to

set the mode of individual dimmers to double.

1. Press [Setup] to display the Setup Menu.

2. Press [2], Output Configuration, and press [Enter].

3. Press [S1], DMX512 Port, enter the port to configure (port 1 or 2). You

may also use [↓] to select a port.

4. Press [Enter].

5. Press [1] to set the port for Dimmer Double mode or [0] to set the port

for Normal mode.

6. Press [Enter] twice to confirm your choice.

7. Display identifies mode as either Normal or Double.

Setting DMX512 speed

If your console is controlling a dimming system that requires a slower

DMX512 signal, specify this in the Output Configuration screen

The console is designed to run at the highest rate provided for in DMX512

specifications. Some dimming systems (including some Colortran ENR™

dimmers) may require a signal slower than the full DMX512 specification.

If this proves necessary, you may reset the console’s signal speed.

Speed choices are Slow, Medium, Fast, and Max. When installed, the

console defaults to Max. If you have problems with outputs flashing,

fades not running smoothly, or unselected dimmers rising spontaneously,

experiment with slower speeds until the symptoms disappear. If the

symptoms persist, please call ETC Technical Services at the office nearest

you.

To reset the DMX512 signal speed, follow these steps:

1. Press [Setup] to display the Setup Menu.

2. Select 2, Output Configuration, and press [Enter].

3. Press [S4], DMX512 Speed.

4. Press [0] for Max, [1] for Fast, [2] for Medium, or [3] for Slow. The

speed you choose appears in the upper right corner of the display.

5. Press [Enter] to confirm your choice. The display shows the speed

setting.

1 2 ... 323 324 325 326 327 328 329 330 331 332 333 ... 379 380

Comentários a estes Manuais

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Especificações Página 328

Comentários a estes Manuais