Electronic Theatre Controls Emphasis Lighting Control System Especificações descarregar pdf (Página 305)

Express 125/250 User Manual, v.3.1 291

Resetting loop time

A time code program loop plays from the first event time to the last event

time, then resets and plays again. Any events with code times before the

first time or after the last time are ignored. The resettable loop time can

run from five seconds to 24 hours.

113

If you are running a time code program from an external clock, the external

clock will control the loop time with its own first event time and last event

time settings. To provide synchronized internal clock backup, you must

set the first event time and last event time in the Time Code Events

display to correspond exactly with those times set for the external clock.

Otherwise events might be missed until the two clocks synchronize. It

takes at least 5 seconds for external and internal clocks to synchronize.

Use this procedure to set loop times either when running on the internal

clock alone or when running from an external clock with internal clock

backup.

113.

If the loop is set to less than five seconds, the internal clock resets it to five

seconds from the loop’s starting time.

Keystrokes:

Actions:

1. Press [S7] until [S8] reads

Reset Loop.

2. Press [S8], Reset Loop.

Prompt reads:

Enter first valid frame of internal

time, then press ENTER. (Press

TIME to edit specific fields)

3. Press [1][0][0][0].

Sets ten seconds as the starting time

for the time code program

4. Press [Enter].

Prompt reads:

Enter last valid frame of internal

time, then press ENTER. (Press

TIME to edit specific fields)

5. Press [5][0][0][0][0] then

press [Enter].

Sets the time code program to reset at

the five minute mark

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 379 380

Sem comentários

Electronic Theatre Controls Emphasis Lighting Control System Especificações Página 305