Electronic Theatre Controls PARADIGM Manual de Instalação descarregar pdf (Página 21)

3 Terminate Wiring 17

Connect Control Wiring

Low voltage data connects to pluggable connectors on the left and right input/output boards

of the ERn enclosure. The ERn2 includes only one each left and right I/O board while the

ERn4 includes two of each.

• The left I/O provides termination for contact inputs and outputs, RS-232 serial, and

Ethernet control.

• The right I/O provides termination for LinkPower, auxiliary power, DMX in, DMX Out,

DMX through, and all enclosure option kits. The right I/O also provides termination for

option modules installed on the bottom module slot of the rack enclosure for enhanced

control and operation.

Note:

All low voltage control cables must be run in separate conduit from power wires in

accordance with local codes.

WARNING:

RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all power to

the rack before working in the enclosure could result in serious injury or

even death.

Right I/O boards

Left I/O board(s)

Wire tie down locations

are provided on the rear

panel.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Sem comentários

Electronic Theatre Controls PARADIGM Manual de Instalação Página 21