Electronic Theatre Controls Sensor Especificações

CE Sensor Rack (ESR Series) ECEM to CEM3 Retrofit ManualRevision A®Copyright © 2011 Electronic Theatre Controls, Inc.All Rights reserved.Product infor

8 CEM3 Sensor ESR Rack Retrofit ManualTransfer DMX WiresWhen transferring wire groups be sure to transfer all wire groups (except those designated as

2 The Retrofit 9Backplane SettingsUpgrade kit backplanes ship from the factory with all DIP switches in the off (down) position. You will have to set

10 CEM3 Sensor ESR Rack Retrofit ManualTerminating the ethernet cable inside the rackSince you will be adding ethernet capability to your ESR rack, ET

2 The Retrofit 11becomes stressed or pinched.Step 5: Insert the backplane tabs in the sides of the rack.Step 6: With the tabs fully inserted in the si

12 CEM3 Sensor ESR Rack Retrofit ManualChange out the Beacon PCBStep 1: Remove the top four dimmer modules from the rack to allow access to the PCB.St

2 The Retrofit 13Repeat the above steps for the remainder of connected racks.Verify the RetrofitStep 1: Put the dimmer modules back in the rack in the

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

ETC permits the reproduction of materials in this manual only for non-commercial purposes. All other rights are reserved by ETC.ETC®, and Sensor® are

Introduction 1IntroductionThis manual is intended to guide ETC Service Technicians through the process of upgrading existing CE Sensor rack installati

2 CEM3 Sensor ESR Rack Retrofit ManualSafetyPlease note the following safety warnings before use:• Disconnect power from the racks before all maintena

1 Unpack and Organise 3Section 1Unpack and OrganiseThe table below lists the parts and components needed to retrofit a CE Sensor rack (ESR12, 24, 36 o

4 CEM3 Sensor ESR Rack Retrofit ManualRequired Tools#1 Phillips screwdriver#2 Phillips screwdriver6mm flat head screwdriverPVC Electrical tapeHeat gun

2 The Retrofit 5Section 2The RetrofitPreparationStep 1: Use Sensor Configuration Editor and a SLTA if you wish to download and save the current Sensor

6 CEM3 Sensor ESR Rack Retrofit Manualthrough the standoffs on the side of the backplane into the rack metalStep 5: Pull backplane towards the front o

2 The Retrofit 7Step 17: Disconnect the three Molex power connectors and the small relay control connector from the fan filter relay board.Step 18: By